Table of Contents
Advertisement
Main menu - Channel search
Manual channel search
After calling up the menu, you will see the
following on-screen display:
The
buttons allow you to select
the parameters you want to change for the
search.
Satellite and position
Use the
buttons to select the satellite on which the transponder you want to search is located. By
pressing the
button at this point, you can view a list of the installed satellites. Use the
buttons
to select the satellite you want and confi rm your selection with the
button. Make sure your receiver is
aligned to this/these satellite(s). If you want to search several transponders on one satellite, you should start
an automatic search of the transmitting satellite.
Transponder frequency
Use the
buttons (transponder frequency already saved) or the number pad (transponder frequency
not yet saved) to select the transponder frequency on which the channel being sought is transmitted. By
pressing the
button at this point, you can view a list of the transponders stored for the selected satellite.
Use the
buttons to select the transponder you want and confi rm your selection with the
button.
At the bottom right of the screen display, the receiver will show the current signal strength and signal quality
of the selected transponder.
The "DVB Type", "FEC", "Polarisation" and "Symbol Rate" options only need to be specifi ed if the
transponder has yet to be stored.
DVB type
Press the
buttons to select whether you want to search for standard channels (DVB-S (SD)) or for
HDTV channels (DVB-S2 (HDTV)).
93
Advertisement
Table of Contents
