Mainmenu - Search Channel; Automatic Channel Search; Manual Channel Search; Search With Service Id - Kathrein UFS 940sw Operating Manual

After calling up the menu you will see
the following display:
You have three different search options:

- Automatic Channel Search

- Manual Channel Search

- Search with service ID


Use the buttons to select the
desired search type and confi rm your

selection using the
After calling up the menu you will see
the following display:

The buttons allow you to select
different sets of parameters for the
search.
Satellite

Using the buttons, select the satellite to be searched. Make sure your reception system is
aligned to the selected satellite. You can search only one satellite at a time. If you have connected
a multi-feed reception system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East),
you must repeat this procedure once for each satellite.
You can however start the fi rst installation again, in the course of which a channel search of all the
satellites you selected is performed.
Channel Search Mode

Use the buttons to select the type of channels that are to be searched for. You have three
options:
94

Mainmenu - Search Channel

button.
Automatic All transponders for the satellite
Channel you selected will be searched
Search
Manual Only the selected transponder
Channel for the satellite you selected will
Search be searched
Search with Search for a specifi c channel
Service ID using its service ID