Search With Service Id - Kathrein UFS 925 Operating Instructions Manual

Main menu - Search Channels

Search with service ID

After calling up the menu, you will see the
following on-screen display:

The buttons allow you to select
the parameters you want to change for
the search.
Satellite

Use the buttons to select the satellite that is transmitting the channels to be searched. By
 
pressing the button at this point, you can view a list of the installed satellites. Use the buttons

to select the satellite you want and confi rm with the button. Make sure your reception system is
aligned to this/these satellite(s).
Transponder frequency

Use the buttons (transponder frequency already saved) or the number pad (transponder
frequency not yet saved) to select the transponder frequency on which the channel being sought

is transmitted. By pressing the button at this point, you can view a list of the transponders stored

for the selected satellite. Use the buttons to select the desired transponder and confi rm with

the button. At the bottom right of the screen display, the receiver shows the current signal
strength and signal quality of the selected transponder.
The "DVB type", "FEC", "Polarisation" and "Symbol Rate" options only need to be specifi ed if
the transponder has yet to be stored.
DVB type

Use the buttons to select whether you want to search for standard channels (DVB-S (SD)) or
for HDTV channels (DVB-S2 (HDTV)).
FEC

Use the buttons to select the applicable error rate (Viterbi rate). When searching for
DVB-S(SD) transponders you need not state the error rate. Instead, "Automatic" appears permanently.
When searching for DVB-S2(HD) transponders you must state the correct error rate. Either QPSK 1/2,
2/3, 3/4, 3/5, 4/5, 5/6, 8/9, 9/10 or 8PSK 2/3, 3/4, 3/5, 5/6, 8/9 or 9/10.
97