Automatic Channel Search - Kathrein UFS 925 Operating Instructions Manual

After calling up the menu, you will see
the following on-screen display:

The buttons allow you to select
the parameters you want to change for
the search.
Satellite

Now use the
the setting "All". If "All" is selected, all the individual satellites you have set up will be searched for
new channels. Make sure your reception system is aligned to this/these satellite(s).
Channel Search Mode

Use the buttons to select the type of channels you want to search for. You have three options:
- "free & scrambled"
- "only free"
- "scrambled only"
To view encrypted channels you need an appropriate CI (Common Interface) module and a
valid Smartcard together with a valid subscription to the relevant Pay TV provider.
NIT search (network search)

Use the buttons (On/Off) to select whether a network search should be performed. If you set
the network search to "Off", only the factory default transponders for the satellite(s) you previously
selected will be searched for new and as yet unsaved channels. If you set the network search to "On",
the transponder network enables additional transponders that have not yet been stored to be located.
These are then stored and searched for new channels in the same way as the existing transponders.
Once you have defi ned all the settings, use the
fi eld and confi rm the start of the search using the
Main menu - Search Channels

Automatic Channel Search

buttons to choose between the individual satellites you have set up, or select
All channels are searched for
Only free-to-air channels are searched for
Only encrypted channels are searched for

buttons to switch to the "Start Search" selection

button.
93