Disassembly For Repair - Kenwood TK-250 Service Manual

DISASSEMBL Y FOR REPAIR
TK-250
1. Loosen the two screws (
0 )
and remove the frame
assembly from the case.
Note:
The case is stiff because of internal waterproofing. To avoid
marring the set wh en pulling it out, use a screwdriver covered
with a piece of cloth to depress the
+
side of the main unit báttery
connector and remove the case.
2. Remove the two shield plate screws (
f.) ),
the speaker
connector, the three contral printed circuit board screws
( @ ) and the two side switch FPC screws (
0 ).
3.
Flip
over the control printed circuit board and remove the
three connectors (
0 ).
3