Disassembly For Repair - Kenwood TH-235A Service Manual

TH-235A/E/234
DISASSEMBLY FOR REPAIR
Removing the case.
1. Remove the three long screws ( @ ) of the rear case. Then, 3. Remove the Chassis board while raising it in the direc-
remove the two knobs ( @}, and remove the rubber panel tion of the arrow (@).
{ © ) while taking care not to give scar on it. Remove the The knob (@) is removed at the same time.
rear case in the direction of the arrow. Remove the cap The RF board can be removed from the chassis ( @ ) by
{Q@) too. removing the four screws (@) and the soldering (@).
\
/ Vax °
TX-RX UNIT = /
<eN ob TX-RX UNIT \e
WE J (CONT) BS
4. Turn over the chassis board in the direction of the arrow
(@).
The Control board can be removed from the chassis
{@) by loosening the hexagon nut ( ®) and remov-
ing the screw (@).
2. Remove the holder ( @ ) by lifting it up in the slanting
upward direction while taking care not to bend the battery
terminal ( @).