Table of Contents
Advertisement
INSTALLATION
TK-250
Keypad attachment
method
5. Loosen the two screws (
0 )
on the underside of the
frame assembly and remove the frame assembly from
the case.
Note:
The case is stift because of internal waterproofing. To avöid
marring the set when pulling it out, use a screwdriver covered
with a piece of cloth to depress the + side of the main unit battery
connector and remove the case.
6. Remove the two screws (
(j) )
and remove the shield
plate.
Insert the keypad flat cable into the connector(CN204),
fold the flat cable as shown in the figure, so that the
cushion is inserted (
0 ),
and with the keypad bent back
out of the way, press it into place.
7. While pressing on the flat cable of the keypad, bend it
under the shield plate, " sandwich"
it there, replace the
shield plate and tighten the screws.
Pee10ft the keypad adhesive's
backing material ( @ ),
align the projections atop the shield plate with the holes
( 11 ) in the keypad, press it firmly into place and return
the frame assembly to the case.
7
Hide quick links:
Advertisement
Table of Contents
