Disassembly For Repair - Kenwood TH-22A Service Manual

TH-22A/AT/E
DISASSEMBLY FOR REPAIR
Removing the case
1. Remove the two long screws (@) of the rear case.
Then pull out the two knobs (@) and remove the rubber
panel (®).
2. Press on the part of the case with a claw (@) and take apart
the upper and lower cases(@).
Note: As the cases are connected with an FFC cable, take
care not to cut the cable when taking apart the cases.
Removing the units
1. Remove the four screws (@) that are holding the TX-RX
it from the case. e @ ©