Kenwood TK-250 Service Manual page 12

TK-250
REALIGNMENT
12
4-3 Self programming mode{Function-setting mode)
Test mode
.!~
1. Destination set
[J~
2. Battery saver
[~~
3. Time-out timer
~
4. Scan
G
5. Delate/ Add activity
---
[PlT]
,
6. Talk arround activity
--
[PlT]
,
7. Power select activity
--
[PlT]
,
8. Monitor mode set
[J~
9. Beep mode set
~
[PTT]
[TA]
END
In the self programming mode(function-setting mode). the
functions are set in the order listed below. When the [PTI]
key is presed, the displayed data is written into the
E2PROM, and the next item can be set.
• ( ): Initial value
1) Destination set
When the channel selector is turned, the display
changes.
r
UHF1 •...•UHF2 •...•UHF3 •...•UHF4 •...•VHF1 •...•
VHF21
Destination setting configuration
Code
Band
Frequency
IF Frequency
Heterodyne
UHF1 450 -470 45.05MHz LOWER UHF2 470-490 45.05MHz LOWER UHF3 490-512
45.05MHz
LOWER UHF4 406-430 45.05MHz LOWER VHF1 150-174 45.05MHz UPPER VHF2 136-150 45.05MHz UPPER '
2) Battery saver
When the channel selector is turned, the display
changes.
r
OFF •...• S •...• M •...• L (OFF)
I
3) Time-out timer
When the channel selector is turned, the display
changes.
~30 •...•60 •...•90 •...• 120 •...• 150 •...• 180 •...• 210 •...•240 •...•270 •...•300(60)
I
4) Scan
When the channel selector is turned, the display
changes.
r
OFF •...• SCAN(SCAN)
I
5) DELETE/ADD
When the channel selector is turned, the channel
changes.
r
DIA 1 •...•
DI
A2 •...• OFF(DI A2) .•
6) Talk around activity
When the channel selector is turned, the display
changes.
r
TA •...• OFF(T A) .•
7) Power select activity
When the channel selector is turned, the display
changes.
r
LO •...• OFF(LO) •
8) MONITOR mode set
When the channel selector is turned, the display
changes.
i
OFF •...• SI81 •...• SI82 •...• SOL
I
9) BEEP mode set
When the channel selector is turned, the display
chahges.
ION •...• OFF(ON) ~
When the all the items have been set, " END" is dis-
played. If the [PTT] key is pressed, item 1 (Destination
set) appears again. If the [TA] key is pressed, the test
mode returnes (SEL is displayed).
5. Tuning mode
Setting method refer to ADJUSTMENT.