Table of Contents
Advertisement
Adjustment
12
Hook lubrication
.05.05
●
●
62
Requirement
1.
The centrifugal disk 1 must be positioned 1.5 mm in front of the oil ring 3.
2.
When the machine is running at full speed, after approx. 10 seconds a mark should be
made by a fi ne stripe of oil on the strip of paper placed over the needle plate cutout.
2
1
Fig. 12 - 06
The adjustment is only necessary if the wick has been replaced.
When replacing the wick, make sure that the new wick is impregnated with oil.
Move the centrifugal disk 1 (screw 2) according to requirement 1.
Check requirement 2. If necessary, move centrifugal disk 1.
3
Advertisement
Table of Contents
