Pfaff 3511-2/01 Instruction Manual page 19

Sewing / correcting seam programs
●
If this key is pressed, the sewing/correcting seam programs function is switched on. By
operating the pedal, the individual seam sections of a program can be sewn after each
other and corrected if necessary.
PM
●
Press this key to switch the sewing of programmed seam patterns on or off. The specifi c
program parameters are shown in the alphanumerical section of the display.
Line selection
●
If this key is pressed, the activated line in the display is selected. Parameter alterations
can only be made in the current active line. If this function is switched on, the top line of
the display is active.
TE
●
If this key is pressed in the sewing mode, the machine changes to the parameter input
function.
●
If this key is pressed during the seam pattern input the "teach in mode" is selected.
●
If this key is pressed during the parameter input, the altered values are stored and the se-
wing mode is called up.
●
Press this key twice to call up the program management function, see Chapter 10.04
Program Management.
Piece Counter
●
Press this key to switch the piece counter on or off. When the function is switched on the
actual value is shown on the display.
Support roller
●
If this key is pressed during seam programming, the support roller function for the corre-
sponding section of the seam pattern is switched on or off. In programmed sewing with
the seam pattern the support roller retracts in the appropriate seam section.
Corner programming
●
If this key is pressed, the corresponding function is switched on or off. If the function is
switched on, the corner programming function is carried out for the appropriate section
of the seam pattern.
Turning the corner
●
If this key is pressed, the corresponding function is switched on or off. If the function is
switched on, the "turning the corner" function for the current seam section is carried out
for the segment shown on the display.
Controls
19