Table of Contents
Advertisement
12
Hook shaft bearing and toothed belt tension
.05.04
Requirement
1.
The front edge of the hook shaft 6 must be at a distance of 14.5 mm to the needle
center. At the same time, the slot in the hook shaft bearing 1 (see arrow) must be
parallel to the bedplate and pointing opposite to the direction of sewing.
2.
The toothed belt should be tightened in such a way that, when the gauge is pushed
onto the toothed belt, the marking in the gauge window corresponds to the marking
on the bushing.
4
Fig. 12 - 05
●
Align hook shaft bearing 1 (screw 2) according to requirement 1.
●
Push the gauge (Part-No. 61-111 639-76) onto the toothed belt so that it is centred to the
toothed belt and touching the bearing of the sliding shaft. The gauge window must be
facing the hook.
●
Eccentric 3 (screw 4) clockwise in accordance with requirement 2, taking care that the
axial position of eccentric 3 is not altered.
3
1
1
2
14,5 mm
Adjustment
5
61
Advertisement
Table of Contents
