Bluetooth - Yamaha YSP-5600 Owner's Manual

Bluetooth

Problem
Receiving Unable to "Bluetooth" is set to "Off".
connect the unit
"Transmission" is set to "On".
to a Bluetooth
device.
Bluetooth is not selected as the input source.
Another Bluetooth device is connected.
A Bluetooth adaptor, etc. that you want to connect to the unit has a
password other than "0000".
The device does not support A2DP.
As more than 20 devices have been connected, information for the oldest
connection has been deleted.
The unit and device are too far apart.
There is a device (microwave oven, wireless LAN, etc.) outputs signals in
the 2.4 GHz frequency band nearby.
No sound is The device is not set to send Bluetooth audio signals to the unit.
heard or the
Playback on the device has not been performed.
sound is
intermittent via
The device's volume is set to minimum.
the unit.
The unit and device are too far apart.
There is a device (microwave oven, wireless LAN, etc.) outputs signals in
the 2.4 GHz frequency band nearby.
The Bluetooth connection of the unit with the device is disconnected.
Cause
Set it to "On".
Set it to "Off".
Select Bluetooth as the input source.
Terminate the current Bluetooth connection, and connect to the device from
which audio should be received.
Use a Bluetooth adaptor, etc. whose password is "0000".
Connect to a Bluetooth audio device that supports A2DP.
Connect to the device again. The unit is can connect to up to 20 Bluetooth
devices for receiving and transmitting audio. If a new device is successfully
connected to the unit after 20 other devices have already been connected,
the device with the earliest connection date will have been deleted to make
room for the new device.
Position the Bluetooth device so that it is less than 10 m from this unit and
connect the device to this unit.
Move this unit away from the device that is emitting radio frequency signals.
Check that the Bluetooth function of the device is set properly.
Perform playback on the device.
Turn up the volume level on the device.
Move the Bluetooth device so that it is less than 10 m from this unit.
Move this unit away from the device that is emitting radio frequency signal.
Perform Bluetooth connection operations again.
Remedy
APPENDIX ➤ Troubleshooting
See page
83
83
47
46, 47
46
106
46, 47
46, 47
–
–
–
–
46, 47
–
47
95
En