Yamaha YSP-5600 Owner's Manual page 98

Problem
The Internet radio cannot be The selected Internet radio station is currently not available.
played.
The selected Internet radio station is currently broadcasting silence.
Access to the network is restricted by the firewall settings of your network
devices (such as the router).
The dedicated apps for The MAC address filter is enabled on the unit.
mobile device does not detect
the unit.
The unit and mobile device are not in the same network.
Firmware update via the It may not be possible depending on the condition of the network.
network (Network Update)
fails.
The iPod does not recognize The unit and iPod/mobile device are connected to different SSIDs on the
same access point.
the unit when using AirPlay.
The app installed on a mobile
device does not recognize the
unit.
The unit cannot connect to The wireless router (access point) is turned off.
the Internet via a wireless
The unit and the wireless router (access point) are too far apart.
router (access point).
There is an obstacle between the unit and the wireless router (access
point).
Wireless network is not There is a device (microwave oven, wireless LAN, etc.) outputs signals in
the 2.4 GHz frequency band nearby.
found.
Access to the network is restricted by the firewall settings of the wireless
router (access point).
Cause
There may be a network problem at the radio station, or the service may
have been stopped. Try the station later or select another station.
Some Internet radio stations broadcast silence at certain of times of the day.
Try the station later or select another station.
Check the firewall settings of your network devices. The Internet radio can
be played only when it passes through the port designated by each radio
station. The port number varies depending on the radio station.
In "MAC Address Filter" in the setup menu, disable the MAC address filter
or specify the MAC address of your mobile device to allow it to access to
the unit.
Check the network connections and your router settings, and then connect
the unit and mobile device to the same network.
Update the firmware via the network (Network Update) again or use a USB
flash drive.
Check the network connections for the unit and your mobile device, and
connect them to the same SSID.
Turn on the wireless router (access point).
Place the unit and the wireless router (access point) closer to each other.
Move the unit and the wireless router (access point) in a location where
there are no obstacles between them.
Move this unit away from the device that is emitting radio frequency signals.
Check the firewall setting of the wireless router (access point).
Remedy
APPENDIX ➤ Troubleshooting
See page
–
–
–
81
–
88
–
–
–
–
–
–
98
En