Yamaha YSP-5600 Owner's Manual page 54

10
Display the Wi-Fi setup screen on the iOS device
z
and select the unit from "SETUP A NEW AIRPLAY
SPEAKER...".
Follow the on-screen instructions displayed on the iOS
device.
Using the WPS push button configuration
You can easily set up a wireless connection with one push of the
WPS button on the wireless router (access point).
1
z
Press the key to turn on this unit.
2
Press and hold the WPS key on the remote control
for at least 3 seconds.
"Press WPS button on Access Point" will be displayed in the
/
ENTER
front panel display.
SETUP ( )
• To cancel configuration, press any key other than the WPS key.
3
Push the WPS button on the wireless router (access
point).
WPS
When a connection has been established, "Completed" will
be displayed in the front panel display.
If "NotConnect" is displayed, repeat the procedure from
step 1 again, or see the information below to try another
connection method.
• The WPS button cannot be used to establish a wireless connection if your
wireless router (access point) uses WEP encryption, or if the router's MAC
address filter is enabled. See "Searching for a wireless router (access point)"
(p. 54) to establish a connection.
• The WPS button cannot be used to establish a wireless connection if your
wireless router (access point) is configured so that it does not broadcast its SSID.
See "Setting up the wireless connection manually" (p. 56) to establish a
connection.
• "WPS Button" under "Wireless (Wi-Fi)" in the setup menu can also be used to
configure a connection using the WPS button. Follow the on-screen instructions.
W i r e l e s s ( W i - F i )
S e l e c t a s e t u p
· W P S B u t t o n
· S h a r e W i - F i S e t t i n g s
· A c c e s s P o i n t S c a n
· M a n u a l S e t t i n g
· P I N C o d e
[ E N T E R ] : O K
[ R E T U R N ] : C a n c e l
About WPS
WPS (Wi-Fi Protected Setup) is a standard established by the
Wi-Fi Alliance, which allows easy establishment of a wireless
home network.
Searching for a wireless router (access
point)
Find and connect to a nearby wireless router (access point).
1
z
Press the key to turn on this unit.
2
Turn on the TV and switch the TV input to display
video from the unit (HDMI OUT jack; p. 28).
3
Press the SETUP ( ) key twice.
The setup menu is displayed on the TV screen.
4
Use the / keys to select "Network", and then
press the ENTER key.
5
Use the / keys to select "Network Connection",
and then press the ENTER key.
NETWORKS ➤ Connecting to a network
m e t h o d .
( i O S )
54
En