Yamaha YSP-5600 Owner's Manual page 94

Problem
Power of the Wired A system control cable used to connect the subwoofer to the unit is not
subwoofer and firmly connected.
this unit is not
Wireless The subwoofer's power function setting is not properly configured. (The
turned on and
power function setting varies depending upon the subwoofer used. See
off at the same
documentations supplied with the subwoofer for more information.)
time.
The image is not displayed on TV The HDMI cable is not securely connected.
screen.
Menu screen of this unit is not The input switch of TV is not set correctly.
displayed.
A digital or high-frequency The unit may be placed close to digital equipment or high-frequency
equipment produces noises. equipment.
The HDMI control function does "HDMI Control" is set to "Off".
not work properly.
The HDMI control function is disabled on your TV.
The number of the connected HDMI devices exceeds the limit.
Amplifiers (AV amplifiers, sound bars, etc.) other than the unit are
connected to the TV or a playback device with an HDMI cable.
Sound beams for the front "Front" of "Channel Out" is set to "Stereo".
channels cannot be adjusted
manually.
Audio delay control function is The TV does not support the audio delay auto adjustment feature.
not effective even "Audio Delay"
is set to "AUTO".
"Disable" appears in the front The key is unable to function in the current status of the unit.
panel display after key operation.
Cause
Connect the cable firmly.
Turn on the subwoofer manually.
If a Yamaha subwoofer has been connected via the SYSTEM CONNECTOR
jack, configure the subwoofer's setting so that it turns on/off when the unit is
turned on/off.
Some subwoofers have a function that turns them on when the transmission
of audio signals by the unit is detected and off when no signal is detected,
and/or a function that allows you to specify the strength of audio signals
detected by the subwoofer. Be sure that these subwoofer functions are
properly configured.
Connect the HDMI cable properly.
Set the TV's input source to this unit.
Move the equipment away from the unit.
Set "HDMI Control" to "On".
Refer to documentation supplied with your TV and check the setting.
Disconnect some of the HDMI devices.
Connect only this unit to the TV or a playback device for use as an amplifier.
Set to "Beam".
Adjust timing of sound output manually from "Audio Delay" in the option
menu.
Remedy
APPENDIX ➤ Troubleshooting
See page
25
–
25
–
22, 23
28
–
77
–
–
–
73
85
–
94
En