When "AUTO SETUP" in the "IntelliBeam" menu (p. 31) is used, recommended beam settings are automatically applied by this unit. However, "Horizontal Angle", "Vertical Angle",
"Beam Travel Length", "Focal Length" (except "Center"), and "Image Location" settings can later be fine-tuned.
The output method for each channel can also be specified in "Beam" menu.
• When manually adjusting sound beams for the front channels, set "Front" for "Channel Out" to "Beam". Adjustment is not possible if "Front" is set to "Stereo".
Horizontal Angle
➜
Setup Menu
Beam
Adjust the horizontal angle of sound beams for each channel using test tones.
Adjust toward L (left) to move the direction of the output to the left and adjust toward R
(right) to move it to the right.
Beam angle
Angle to
left
Settings
Front L, Front R, Center, Surround L, Surround R
Adjustable range
L90° to R90°
Left
key:
Increase angle.
key:
Decrease angle.
➜
Horizontal Angle
Setup Menu
Adjust the vertical angle of sound beams for each channel using test tones.
Adjust upward to move output direction up, and adjust downward to move output