Fcc Notice - Renishaw RLI20-P User Manual

FCC notice

This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
The user is cautioned that any changes or modifications not expressly
approved by Renishaw plc or authorised representative could void the
user's authority to operate the equipment.
EC compliance c
Renishaw plc declares that the RLI20 interface complies with the
applicable directives, standards and regulations.
A copy of the full EC Declaration of Conformity is available at the
following address:
www.renishaw.com/RLECE
WEEE
The use of this symbol on Renishaw products and/or accompanying
documentation indicates that the product should not be mixed with
general household waste upon disposal. It is the responsibility of the end
user to dispose of this product at a designated collection point for waste
electrical and electronic equipment (WEEE) to enable reuse or recycling.
Correct disposal of this product will help to save valuable resources and
prevent potential negative effects on the environment.
For more information, please contact your local waste disposal service
or Renishaw distributor.