Installing The Sd Memory Card (32 Mb Up To 512 Mb) - Toshiba E-STUDIO190F Service Manual

8.7.

Installing the SD Memory Card (32 MB up to 512 MB)

8.7.1. Installation
CAUTION!
Turn the Power Switch on the Rear Side of the machine to the OFF position, and then
unplug the AC Power Cord before beginning installation. (During a Lightning Storm, to
prevent electrocution disconnect the Telephone Line Cable first before unplugging the
AC Power Cord.)
Caution:
Do not remove the SD Memory Card or turn the power OFF during Formatting or while Updating the
Firmware.
Note:
1. When a New (Blank) SD Memory Card is detected for the first time, a prompt for Formatting will
appear on the LCD. The machine will format the SD Card for DATA (used for Fax Image, 1,000 Station
Auto Dialer, JOB MIB Data, etc.), and it takes approximately 3 to 12 min. to format depending on the
manufacturer, SD Memory Card size or Data Access Speed of the SD Card.
2. To Update the Firmware or to Format an SD Memory Card using the F9-15 Service Mode takes
approximately 5 sec. Refer to 3.5.6. (Formatting the SD Memory Card).
(1) Disconnect the Telephone Line, LAN and/or
USB Cables if connected.
(2) Remove 1 Silver Screw.
(3) Remove the SD Card Cover.
(4) Gently insert the SD Memory Card as illustrated
(Logo facing outward).
Caution:
Forcing the card into the slot may cause damage
to the card or machine.
(5) Reinstall the SD Card Cover.
(6) Plug the AC Power Cord and turn the Power
Switch on the Rear Side of the machine to the
ON position.
(7) Reconnect the Telephone Line, LAN and/or
USB Cables.
252