Toshiba E-STUDIO190F Service Manual page 53

2.2.7. Fuser Unit
CAUTION:
To prevent from getting burned, do not install, remove, clean or make adjustments when the Fuser Unit is
hot.
(1) Remove the Inner Cover Assembly. (Refer to
2.2.6.)
(2) Disconnect 2 Harnesses by pressing down on
the connector latches with a small screw driver.
(3) Open the Rear Cover.
(4) Remove 4 Screws (T9).
(5) Remove the Upper Exit Roller Holder (1201).
(6) Remove 1 Screw (Y3).
(7) Remove the Fuser Harness Cover (1023).
(8) Disconnect the Harness on the LVPS.
53