Toshiba E-STUDIO190F Service Manual page 75

12. Reconnect the Telephone Line, LAN and/or USB Cables.
13. Turn the Power Switch on the back of the machine to the ON position.
14. Reprogram the F5 & F6 Parameters according to the lists printed in Step 1 above if the settings are
other than factory default.
2) When a DATA SD Card is installed
1. Before starting, print the F5/F6 Parameters List (Copy Service Mode F9-03-00).
2. Turn the Power Switch on the back of the machine to the OFF position. (During a Lightning Storm,
to prevent electrocution disconnect the Telephone Line Cable first before unplugging the AC Power
Cord.)
3. Disconnect the Telephone Line, LAN and/or USB Cables.
4. Remove the DATA SD Card from the machine.
5. Install the appropriate Master Firmware SD Memory Card into the machine.
6. Turn the Power Switch on the back of the machine to the ON position.
7. Press "FUNCTION", "ORIGINAL SIZE" keys and then Key "3" on the keypad sequentially.
8. Perform the Copy Service Mode F9-07-00 (Update From Master SD Card).
9. The firmware is copied into the machine.
Selecting the "Auto Mode", copies all the necessary firmware at once.
10. After the update is completed, the machine reboots itself and returns to standby.
11. Turn the Power Switch on the back side of the machine to the OFF position.
12. Remove the Master Firmware SD Memory Card from the machine.
13. Reinstall the DATA SD Card into the machine.
14. Reconnect the Telephone Line, LAN and/or USB Cables.
15. Turn the Power Switch on the back of the machine to the ON position.
16. Reprogram the F5 & F6 Parameters according to the lists printed in Step 1 above if the settings are
other than factory default.
Note:
After the update is completed, the machine reboots itself and returns to standby mode.
Selecting the "Auto Mode", prompts the unit to check the configuration and installed options, and all
the necessary firmware is updated automatically.
Confirm that the update was successfully completed by checking the Firmware Version with F9
Parameters F9-02-xx.
Caution:
If the unit does not boot up properly in Step 8, refer to 3.5.7. (Firmware Emergency Recovery)
3.5.5. Creating a Master Firmware SD Memory Card using a PC
1) Install the "SD Memory Card Firmware Writing Tool" to your PC.
The "SD Memory Card Firmware Writing Tool" is in the CD. Please refer to the Readme file for
additional details.
2) Preparing the Firmware Code
Double click the appropriate Destination Shortcut Batch File and copy the Firmware Code File on the
CD-ROM to the Firmware Data Folder in your PC. Note that the files in the Archive will be extracted
automatically into the designated folder when the Archived file (.exe) is Double-clicked.
Example:
From:
Destination Shortcut Batch File: D:(CD-ROM Drive) \ xFirmware \ USA.bat
Firmware Code File:
To:
Firmware Data Folder:
UF-8000_xx_xxxxxx.exe
C:\ Pcc \ Fup \ Data
75