Power Unit; Transport; Mounting The Brackets; Technical Requirements - AAT Movilino User Manual

F
Please be careful when going downhill with full batteries. The drive
down generates electricity which charges the batteries additionally.
This may lead to excess voltage which in turn may lead to a turning
off of the movilino. During regular use the device reduces its speed
automatically to avoid overvoltage.
F
If the batteries are empty, the device goes into undervoltage. It
stops. Yet the hub motor still drives upward so you may push the
wheelchair manually.
4.9 Power unit: The movilino plus its power unit is for the most part co-
vered by the housing. Nevertheless, please make sure that while driving you
do not put fingers or hands into the rotating area (e.g. chain wheel or driving
pinion). Always keep a safe distance.
4.10 Transport: You may remove the movilino's handle unit (see chapter
3.1) for transportation. Please lift the power unit exclusively by its recessed
handle (see chapter 2.2.2)
F
Always turn off the movilino for transportation!
F
When you transport the device in vehicles, please secure it accor-
ding to the relevant legal regulations in your country.
4.11 Mounting the brackets: Attaching the movilino's brackets to the
wheelchair or making changes on said brackets may only be performed by
the company AAT Alber Antriebstechnik or their authorized dealers.
The movilino may only be attached to wheelchairs which must be checked
according to generally acknowledged technical norms, and their operator's
manuals must be applied when using the movilino.
Before each use please check all the holding devices and attachments. Also
make sure that the device itself functions properly. Should anything not work
you may not use the movilino. In that event, please contact your local dealer.
4.12

Technical requirements:

F
You may not remove the wheelchair's wheels!
Please always check the air pressure of pneumatic steering rollers. The movi-
lino driving qualities could be affected negatively, if there is not enough air
in the rollers.
The air pressure in the wheelchair's wheels must correspond to the wheel-
chair manufacturer's stipulations.
The running wheels' condition also must be checked before each use.
Should the wheels have reached their wear limit (see chapter 4.4) you may
not use the movilino.
After you have inserted the safety chip for the engine immobiliser into its
proper slot on the handle the movilino is ready to go. Therefore, please al-
ways check whether the chip is properly inserted before you use the device.
The wheelchair's locking brakes must be attached in such a way that the at-
tendant may reach them easily.
It is indispensible to use anti-tilt support. Please make sure that they are not
jammed before each use. Also never drive backwards against a wall with
mounted anti-tilt support.
23
movilino