AAT Movilino User Manual page 15

3.2.3 Insert the movilino into the lower bracket on the wheelchair
1. Please use the locking brakes of your wheelchair to avoid any move-
ment of the chair while the movilino is being mounted.
2. Tilt the movilino slightly backwards. As soon as the device sits on its
wheels you may push the movilino back and forth. This only works if
you keep the device tilted backwards!
F
These helping wheels are only active when the device is tilted!
F
Make sure that the anti-tilt support is removed!
3. Now push the movilino from behind the wheelchair under the chair
until the lower rod Œ is inserted all the way into the lower bracket 
of the wheelchair.
3.2.4 Insert the movilino into the upper bracket on the wheelchair
There are two possibilities to insert the movilino into the upper brackets on
the wheelchair.
Possibility 1:
1. Tilt the movilino forward to lift the upper bracket.
2. The movilino, aligned in the center of its upper support Ž slides into
the upper brackets  the adjusting rings rest snugly against the in-
side of the brackets on both sides.
Possibility 2:
3. Plug the power cable into the movilino's battery pack as described in
chapter 3.3.
4. Insert the safety chip for the engine immobiliser into its appropriate
slot.
5. Now turn on the device. At this point the running wheels are automa-
tically moving downward and the upper support is lifted up.
6. Is the movilino aligned in the center of its upper support Ž slides
into the upper brackets  the adjusting rings rest snugly at the insi-
de of the brackets on both sides.
F
Please make sure that the lower support is properly hooked into the
lower brackets on the wheelchair! This goes for both possibilities!
F
The adjusting rings must always be at the inside of the brackets!

Œ
15
movilino

Ž