Governor Shaft - Toro Workman 1100 Service Manual

1. Screw
2.
IMPORTANT: To prevent the screws that secure the
governor fork and stopper to the governor shaft
from loosening, apply Loctite Blue No. 242 or equiv-
alent to the screw threads.
12 to 16 in–lbs
(1.4 to 1.8 N–m)
1. Governor fork
2. Governor shaft (greased surface)
E. Adjust governor fork center to the center of the
ball bearing hole. Also, adjust thrust clearance of
the governor shaft to less than 0.5 mm.
Drive Train
4
1
Stopper
3
3
2
Figure 65
3. Governor fork
4. Case (RH)
D. Secure stopper and governor fork to the governor
shaft with both screws.
1
Figure 66
3. Screw
F. Torque screws from 12 to 16 in–lbs (1.4 to 1.8
N–m).
Page 5 – 40
0.5 mm
2
Workman 1100/2100/2110