Adjust Ground Speed (Vehicles Without Transaxle Governor) - Toro Workman 1100 Service Manual

Adjust Ground Speed (Vehicles Without Transaxle Governor)

Note: Workman 2100 and 2110 models with serial
numbers above 240000001 are not equipped with a
transaxle governor. These models use an engine gover-
nor for speed control.
WARNING
Vehicles operating at ground speeds greater than
the recommended speed will require further
distances to fully stop. Do not adjust ground
speed greater than specified.
1. Park machine on a level surface, stop engine, set
parking brake, and remove key from the ignition switch.
Raise and latch cargo bed.
2. Lock transaxle into neutral (see Transaxle Neutral
Position in Chapter 1 -- Safety).
3. Verify engine speed to ensure correct ground speed
as follows:
A. Start engine and hold accelerator pedal to the
floor.
B. Using a tachometer, verify that engine RPM is
3300 RPM with the accelerator pedal to the floor.
C. If engine RPM is incorrect, refer to the Briggs and
Stratton Repair Manual found after Chapter 3 for
governor adjustment procedure.
4. Lower cargo bed.
Workman 1100/2100/2110
1
1. Accelerator cable
2. Accelerator cable end
Page 5 - - 5 Rev. A
3
2
Figure 5
3. Governor control
Drive Train