Toro Workman 1100 Service Manual page 9

Maintenance and Service
1. Only qualified and authorized personnel should
maintain, repair, adjust, or inspect the vehicle.
2. Before servicing or making adjustments to the ma-
chine, stop engine, set parking brake, and remove key
from the ignition switch to prevent someone from acci-
dentally starting the engine.
3. Make sure entire machine is in good condition. Keep
all nuts, bolts, and screws properly tightened.
4. Reduce potential fire hazards. Keep engine area
free of excessive grease, grass, leaves, and accumula-
tion of dirt.
5. Never use an open flame to check level or leakage
of fuel or battery electrolyte.
6. If the engine must be running to perform a mainte-
nance adjustment, keep hands, feet, clothing, and any
parts of the body away from the engine and any moving
parts. Keep everyone away.
7. Do not use open pans of fuel or flammable cleaning
fluids for cleaning parts.
8. Do not adjust ground speed governor. To assure
safety and accuracy, have an Authorized Toro Distribu-
tor check the ground speed.
Workman 1100/2100/2110
9. If major repairs are needed or assistance is required,
contact an Authorized Toro Distributor.
10.Make sure of optimum performance and safety. Al-
ways use genuine Toro replacement parts and accesso-
ries. Replacement parts and accessories made by other
manufacturers could cause damage and be dangerous.
Altering this vehicle in any manner may affect its opera-
tion, performance, and/or durability. Alterations may re-
sult in injury or death. Such use could void the product
warranty of The Toro Company.
Sound Pressure Level
This unit has an equivalent continuous A–weighted
sound pressure at the operator's ear of 80 dB(A), which
is based on measurements of identical machines per
SAE J1174-MAR 85 procedures.
Vibration Level
This unit does not exceed a vibration level of 2.5 m/s
the hands, which is based on measurements of identical
machines per ISO 5349 procedures.
This unit does not exceed a vibration level of 0.5 m/s
the posterior, which is based on measurements of iden-
tical machines per ISO 2631 procedures.
Page 1 – 5
2
at
2
at
Safety