Safety Instructions - Toro Workman 1100 Service Manual

Safety Instructions

The Workman 1100/2100/2110 was tested and certified
by TORO for compliance with the B71.4–1984 specifica-
tions of the American National Standards Institute. Al-
though hazard control and accident prevention partially
are dependent upon the design and configuration of the
machine, these factors are also dependent upon the
awareness, concern, and proper training of the person-
nel involved in the operation, transport, maintenance,
and storage of the machine. Improper use or mainte-
nance of the machine can result in injury or death.
Read and understand the contents of the Operator's
Manual before starting and operating the machine. Be-
come familiar with all controls and know how to stop it
quickly. A replacement manual is available on the Inter-
net at www.toro.com or by sending complete Model and
Serial Number to:
The Toro Company
Attn. Technical Publications
8111 Lyndale Avenue South
Minneapolis, Minnesota 55420–1196
The safety alert symbol means
CAUTION, WARNING or DANGER —
"personal safety instruction". Read
and understand the instruction because it has to
do with safety. Failure to comply with the instruc-
tion may result in personal injury.
WARNING
To reduce the potential for injury or death, comply
with the following safety instructions.
Supervisors, operators, and service persons should be
familiar with the following standards and publications
(The material may be obtained from the addresses
shown):
Supervisor's Responsibilities
1. Make sure operators are thoroughly trained and fa-
miliar with the Operator's Manual and all labels on the
vehicle.
Before Operating
1. Operate machine only after reading and understand-
ing the contents of this manual.
2. Never allow children to operate the vehicle. Never
allow adults to operate it without proper instructions.
Safety
•
Flammable and Combustible Liquids Code:
ANSI/NFPA 30
•
National Fire Protection Association:
ANSI/NFPA #505; Powered Industrial Trucks
ADDRESS:
National Fire Prevention Association
Barrymarch Park
Quincy, Massachusetts 02269 U.S.A.
•
ANSI/ASME B56.8; Personal Burden Carriers
ADDRESS:
American National Standards Institute, Inc.
1430 Broadway
New York, New York 10018 U.S.A.
•
ANSI/UL 558; Internal Combustion Engine
Powered Industrial Trucks
ADDRESS:
American National Standards Institute, Inc.
1430 Broadway
New York, New York 10018 U.S.A.
Underwriters Laboratories
333 Pfingsten Road
Northbrook, Illinois 60062 U.S.A.
The Workman is an off–highway vehicle only. It is
not designed, equipped, or manufactured for use
on public streets, roads or highways.
2. Be sure to establish your own special procedures
and work rules for unusual operating conditions (e.g.
slopes too steep for vehicle operation).
Only trained and authorized persons should operate this
vehicle. Make sure all operators are physically and men-
tally capable of operating the vehicle. Anyone who oper-
ates the vehicle should have a motor vehicle license.
Page 1 – 2
OR
WARNING
Workman 1100/2100/2110