Toro Workman 1100 Service Manual page 38

CAUTION
One person should operate the chain fall or hoist
while the other person guides the engine out of
the frame.
12.Remove engine from the engine mount.
A. Attach a short section of chain between both en-
gine lift tabs.
B. Connect hoist or chain fall to center of chain.
IMPORTANT: Make sure not to damage the engine,
fuel hoses, electrical harness, or other parts while
removing the engine.
C. Slowly remove engine and mounts from the ma-
chine.
13.Remove engine parts and attachments as neces-
sary to repair the engine.
Engine Installation (Fig. 19)
1. If removed, install engine parts and attachments to
the engine.
CAUTION
One person should operate the chain fall or hoist
while the other person guides the engine into the
frame.
2. Install engine to the frame.
A. Attach a short section of chain between both en-
gine lift tabs.
B. Connect a hoist or chain fall at the center of the
short section of chain.
IMPORTANT: Make sure not to damage engine, fuel
lines, electrical harness, or other parts while instal-
ling the engine.
C. Carefully lower engine onto the engine mount.
3. Secure engine to the engine mount with flange lock
nuts and cap screws.
Briggs & Stratton Gasoline Engine
4. Connect the following electrical components:
A. Connect ground cable from the engine at starter/
generator terminal A1 (Fig. 22).
B. Connect engine harness connector to the main
harness connector.
5. Install torque arm to the engine and transaxle.
6. Secure starter rod to the torque arm. Install V–belt to
the engine and starter/generator. Tension and adjust the
V–belt (see Adjust Starter/Generator Belt).
7. Install drive belt (see Service Drive Belt).
8. Install muffler and exhaust pipe to the cylinder heads
(see Muffler Removal).
9. Connect fuel hose to the fuel pump (Fig. 21).
10.Connect the following components:
IMPORTANT: Make sure all hoses and engine open-
ing plugs are removed.
A. Choke and throttle cables to the carburetor and
cable bracket (Fig. 20).
B. Air intake hose to the carburetor (Fig. 21).
C. Breather hose to the crankcase (Fig. 21).
11. Secure choke, throttle, and shift cables to the brack-
et on the front cylinder head with cable tie (Fig. 21).
12.Connect positive (red) cable to the battery. Then,
connect negative (black) cable to the battery.
13.Install cargo bed to the frame.
14.Make sure engine oil level is correct (see Check En-
gine Oil).
15.When starting a new or repaired engine, observe the
following:
A. After starting a cold engine, let it warm up for
about 15 seconds before applying any load to it.
B. Check engine oil level regularly. Be alert for con-
ditions of overheating.
Page 3 – 18 Workman 2100/2110