Toro Workman 1100 Service Manual page 37

Engine Removal (Fig. 19)
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Remove cargo bed to gain access to the engine.
3. Disconnect negative (black) cable from the battery.
Then, disconnect positive (red) cable from the battery.
IMPORTANT: Make sure all hoses and engine open-
ings are plugged after disconnecting. Prevent con-
taminants from entering the engine and fuel system
and damaging the engine.
4. Disconnect the following components:
A. Choke and throttle cables from the carburetor
and cable bracket (Fig. 20).
B. Air intake hose from the carburetor (Fig. 21).
C. Breather hose from the crankcase (Fig. 21).
CAUTION
Read safety precautions for handling gasoline
before working on the fuel system (see Fill Fuel
Tank and Fuel Safety Precautions).
5. Disconnect fuel hose from the fuel pump. Remove
cable tie securing the choke, throttle, and shift cables to
the bracket on the front cylinder head (Fig. 21).
6. Remove muffler and exhaust pipe from the cylinder
heads (see Muffler Removal).
7. Remove drive belt (see Service Drive Belt).
8. Remove V–belt from the engine and starter/genera-
tor by loosening the tension on the belt. Disconnect
starter rod from the torque arm (see Adjust Starter/Gen-
erator Belt).
9. Remove torque arm from the engine and transaxle.
10.Disconnect electrical connections from the following
engine components:
A. Disconnect ground cable to engine at starter/
generator terminal A1 (Fig. 22).
B. Disconnect engine harness connector from the
main harness.
11. Remove four flange lock nuts and cap screws secur-
ing the engine to the engine mount.
Workman 2100/2110
1
3
4
1. Carburetor
2. Throttle cable
5
4
6
1. Choke cable
2. Throttle cable
3. Carburetor
4. Fuel hose
1. Starter/Generator ground cable to engine
2. Starter/Generator terminal (A1)
Page 3 – 17 Briggs & Stratton Gasoline Engine
2
Figure 20
3. Choke cable
4. Cable bracket
7
3
8
1
2
Figure 21
5. Fuel pump
6. Cable tie
7. Air intake hose
8. Breather hose
2
1
Figure 22