Lubrication; Grease Fitting Location; Greasing - Toro Workman 1100 Service Manual

Lubrication

Note: Perform this maintenance procedure at the in-
terval specified in the WORKMANR Maintenance
Schedule. Lubricate more frequently when using this
vehicle for heavy duty operations and after each wash-
ing.
Grease Fitting Locations
1. Each tie rod has a grease fitting on each ball joint, the
one that secures the tie rod to the Pitman arm (Fig 3) and
the joint that secures the tie rod to the front wheel spindle
(Fig 4).
2. The A–arm has a grease fitting for the king pin (Fig
4).
3. The throttle and brake pedal pivots each have one
grease fitting. Note: These fittings are not greased at
the factory. Grease them only when and if the pedals be-
gin to stick (Fig. 5).

Greasing

IMPORTANT: Use No. 2 general purpose lithium
base grease.
1. Wipe grease fitting clean so foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
Workman 1100/2100/2110
2
1. Pitman arm
1
2
1. Tie rod
2. A–arm
1. Grease fitting (brake)
Page 2 – 7 Product Records and Maintenance
1
2
Figure 3
2. Grease fitting
3
3
Figure 4
3. Grease fitting
1
Figure 5
2. Grease fitting (throttle)
2