Service Drive Belt; Replace Fuel Filter - Toro Workman 1100 Service Manual

Service Drive Belt

Inspection
Note: Perform this maintenance procedure at the in-
terval specified in the Operator's Manual or Chapter 2
– Product Records and Maintenance.
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Raise bed and secure with prop rod.
3. Put vehicle transmission in neutral (see Set Neutral
Lock Assembly in Chapter 1 – Safety).
4. Rotate and inspect belt for excessive wear or dam-
age. Replace as necessary.
Replacement
1. Rotate and route belt over the driven clutch.
2. Remove belt from the drive clutch.
3. Place new belt around drive clutch.
4. Rotate driven clutch while routing the belt on.

Replace Fuel Filter

Note: Perform this maintenance procedure at the in-
terval specified in the Operator's Manual or Chapter 2
– Product Records and Maintenance.
WARNING
Use caution when working with fuel system com-
ponents (see Fill Fuel Tank and Fuel Safety Pre-
cautions).
1. Park machine on a level surface, stop engine, en-
gage parking brake, and remove key from the ignition
switch.
2. Raise bed and support with prop rod.
3. Place a clean container under fuel filter (Fig. 10).
4. Remove clamps securing fuel filter to fuel lines.
5. Remove fuel lines from fuel filter.
IMPORTANT: Mount filter so the arrow points in the di-
rection of fuel flow to the carburetor.
6. Install new fuel filter to fuel lines with clamps pre-
viously removed.
Workman 1100/1110
1
1. Drive clutch
2. Driven clutch
1
1. Fuel filter
2. Fuel line
Page 4 – 9
2
3
Figure 9
3. Drive belt
2
3
Figure 10
3. Vacuum line
Kohler Gasoline Engine