HeliArtist EC145 Instruction Manual page 4

1
Tighten the Aluminum Landing Gear to the bottom of
the fuselage using four 2x14mm Self­Tapping Screws
and 2x5mm Washers.
3
Assemble the Aluminum Skids to the Landing Gear
and secure them with CA glue.
5
Disassembly the Tail boom from the heli mechanism.
7
Loosen the screw from the Scorpion Tail System circled
above.
2
Insert the Landing Gear Mounts to the Aluminum
Landing Gear.
4
Tighten the Landing Gear Stairs onto the Landing Gears using
two 2x10mm Self­Tapping Screws for each Stair.
6
Disassembly the Tail Gear Case from the heli mechanism.
8
Replace the belt with a longer one included in the fuselage
and assemble the Scorpion Tail Gear box
the helicopter and set a proper angle as shown above to get
ready for insert to the Heli mechanism and fuselage.
4
with the tail boom of