AVE RegCom-Pro Operation Manual page 91

APPENDIX R
SELLER SHALL NOT BE LIABLE FOR ANY SPECIAL, DIRECT INCIDENTAL OR CONSEQUENTIAL
DAMAGES OF A COMMERCIAL NATURE ARISING OUT THE USE OF OR INABILITY TO USE
SELLER'S PRODUCT BY REASON OF THE FACT THAT SUCH PRODUCT DOES NOT CONFORM
TO THE CONTRACT OR TO ANY EXPRESS OR IMPLIED WARRANTY. SELLER'S MAXIMUM LI-
ABILITY SHALL BE LIMITED TO THE COST OF REPAIR AND/OR REPLACEMENT OF THE PROD-
UCT CLAIMED TO BE DEFECTIVE OR NONCONFORMING, SUBJECT TO SELLER'S RIGHT OF
REMOVAL AND RETURN OF PRODUCT.
All of the foregoing constitute Buyer's sole and exclusive remedy and Seller's sole and exclusive liability for supply-
ing nonconforming or defective Product.
RETURNS
AVE products are fully inspected and carefully packed to ensure you are delivered a quality product in good condi-
tion. If you are not fully satisfied with our product, returns of standard stocking items with no restocking fee can be
made within thirty (30) days of invoice to Buyer. All such returns must have prior consent of Seller by obtaining an
RMA number and must include the sales or delivery receipt showing the date of original purchase and be in an
unused condition contained in its original packaging. Any other returns must have prior written consent of Seller and
are subject to a restocking fee of fifteen percent (15%) and freight charges.
RMA NUMBER
The RMA (Return Material Authorization) number must be obtained by contacting Seller prior to the shipment of the
product for return. The RMA number is valid only for 15 days from the date of issue. The RMA number must be clearly
displayed on all shipping labels.
MASTER RESET
DOING A MASTER RESET CLEARS ALL PROGRAMMING AND
THE RegCom-Pro DEFAULTS TO THE FACTORY SETTINGS.
If you have difficulty entering the main-menu or you changed uP or updated the Firmware in your RegCom-Pro, do the
following procedure exactly: Lightly press and hold in the 3 buttons to the left ("Up", "Down" & "Set"). While holding down
these buttons, press and release the "Reset" button. Then release the other buttons. Wait a few seconds and the
copyright notice will appear on-screen along with the version of software installed in your RegCom-Pro.
Upon powering up the RegCom-Pro for the first time, if the battery is depleted the master reset should be done. However
in some cases the Time/Date display may not have the correct or legible characters. If this occurs, go to the Clock
programming section of the menu and reset the clock and program the correct time. The Time/Date display will then
function properly and any subsequent master resets will not affect the time.
The internal rechargeable NiMH battery needs a full 24 Hr charge if fully discharged to be fully charged.
RegCom-Pro POS / Cash Register Interface
WARNING!
91
LIMITED WARRANTY
APPENDIX S