Electrical Supply - Hobby ONTOUR Series Operation Manual

1
Circuit board (reverse side)
of TFT display

7.3 Electrical supply

CEE external socket
69
7. Installation of electrical devices
General information regarding the TFT display
The time and date are buffered by a 3V 210 mAh, CR2032 type
button cell. If, therefore, the time should be incorrect or the clock
should stop working, this button cell must be replaced. It is moun-
ted on the reverse of the circuit board of the TFT display. To replace
this button cell, the TFT display must be removed from the furniture
front by carefully clipping the chrome-plated frame out of its holder.
You will then see the screws that fasten the plastic part to the furni-
ture. Loosen these screws to detach the display.
When replacing the button cell, please ensure that
plus and minus are in the right direction. Incorrect
polarity may cause the display to become defect.
Electricity for the caravan can be obtained from the following
connections:
- 230 V mains connection 50 Hz
- via the base vehicle if it is connected using the 13-pole plug
(limited functions)
- via a built-in auxiliary battery *. Everything that uses 12 V, such
as lighting, water supply, etc., is available.
Supply via mains connection
The caravan receives its electric power supply via the 230 V CEE
feeder plug on the side wall of the vehicle.