Hobby ONTOUR Series Operation Manual page 70

7. Installation of electrical devices
01.07.15 14:00 -------
14:00
- - - - -
Einstellungsmenü
Datum
Uhrzeit
Temperaturo set
Wecker on/o
01.07.15 14:00 -------
09.01.15
12:30
12:30 23,5 °C 18,0 °C
09.01.15
HOBBY
Hobby-Wohnwagenwerk
Ing. Harald Striewski GmbH
Harald-Striewski-Strasse 15
24787 Fockbek
Deutschland
Displaying the data in the fixed header A
-------
This menu gives an overview of the data in the fixed header A. It
is only possible to exit this menu by using the "Back" function; it
does not automatically switch back to the main menu on the control
01.07.15
panel.
- - - - -
Settings menu (for data in the fixed header A)
-------
The date and time can be set in the Settings menu. Use the control
- 2 °C
knob or the left and right arrows to reach the desired value. Press the
control knob; it is then possible to change the values by turning the
+ 1 °C
knob (right = increase value; left = decrease value) or by using the
"+/-" function. Press the control knob to confirm the changed value.
Only then will it be saved.
It is also possible to calibrate the indoor and outdoor temperatures
shown, as temperature effects on the sensors may lead to a deviati-
on between the temperature displayed and the actual temperature.
The temperature display can be changed by a maximum of +/-12° C.
Exit this menu by using the "Back" function; otherwise, after one
minute, it will automatically switch back to the main menu on the
control panel.
Info menu on the TFT control panel
Information on the device manufacturer is shown here.
66