Hobby ONTOUR Series Operation Manual page 64

7. Installation of electrical devices
Wassertank
Wassertank
automatic
tank
control
automatic
tank
control
Alarm
Batterie-
Batterie-
management
management
Batterie-
management
Charger
Charger
Charger
Battery charger
Soft key menu bar C
This is used to access the individual menus of the components.
Soft keys
The "soft keys" are used to carry out the commands displayed
in the lower menu bar (C). For example, they enable access to
submenus, increase or reduce the values shown, or represent the
Return button ("Back" function).
Control knob
Like the "soft keys", the control knob enables easy navigation bet-
ween the individual menus. Turn the know to select the correspon-
ding menu item or display value shown to the left, or to increase or
reduce values. Press the knob to jump to submenus or confirm a
value that has been changed.
Fresh water tank
The filling level of the fresh water tank can be read off here. The
alarm can be activated (green) above the left soft key (On/Off icon).
If the alarm has been activated, a beep will go off when the tank is
being filled. These beeps will be sent at increasingly shorter inter-
vals while the tank is filling up. The filling level of the fresh water
tank will be automatically updated on the control panel every few
seconds.
Exit this menu by using the "Back" function; otherwise, after one
hour, it will automatically switch back to the main menu on the con-
trol panel.
Battery management*
The current status of the auxiliary battery is displayed in the battery
menu (self-sufficient package). The charging status is shown in the
battery icon; the example shows a fully charged battery.
"U" indicates the current charging voltage, "I" the current charging
current and the remaining time until the battery is discharged is dis-
played in hours. The value "T" indicates the temperature of the bat-
U : 12,3 V
tery; this must not exceed 50° C. A warning message will be sent if
I : 5,3 A
U : 12,3 V
U : 12,3 V
: 6,5 h
the temperature exceeds 50° C and the battery will be shown in red
I : 5,3 A I : 5,3 A
T : 0,0 °C
in the main menu on the control panel. If the battery is overheated,
: 6,5 h
R : 0 : 6,5 h
T : 0,0 °C
it cannot be charged. Should this warning occur repeatedly, the
T : 0,0 °C
R : 0
camper must be taken to an authorised specialist.
R : 0
If the icons for the "Charger" appear, the camper is connected to a
230V mains connection and the charge controller was recognised:
the battery will be charged. If the camper is connected to a 230V
060 Ah GEL mains connection and the icons for the Charger do not appear, the
battery will be charged using a characteristic.
060 Ah GEL
The value "R" shows the calibration check. If "1" is output, the sen-
060 Ah GEL
sor will be calibrated (target state). If "0" is output, the measured
values may deviate slightly and the sensor should be recalibrated.
60