Hobby ONTOUR Series Operation Manual page 65

Lichtsystem
Lichtsystem
Lichtsystem
01.07.15 14:00 -------
01.07.15
14:00
•
01.07.15 14:00 -------
On/Off Timer
01.07.15 14:00 -------
01.07.15 14:00 -------
09.01.2015
10:00 to 14 :30 on
17:00 to 22:00
0:00 to
01.07.15 14:00
09.01.2015
17:00 to 22:00
61
7. Installation of electrical devices
Normally, calibration is carried out automatically, whereby neither
the charging nor the discharge current may be more than 150mA.
The system can be manually calibrated
- while using the 230V mains operation or
- if no electrical device has been switched on in 12V operation.
To do this, the 30A main fuse must be switched off by pressing the
button on the battery container (see "Operation via auxiliary bat-
tery"). Now the sensor can calibrate itself. This process takes ap-
prox. three hours. If the fuse is then switched on again, a value of 1
should be shown on the display.
Exit the menus by using the "Back" function or automatically after
one minute.
Lighting system
Select the desired light in the menu for the lighting system by means
of the control knob or the arrow functions (display: yellow). Press
on the control knob or the left soft key to switch the corresponding
light on or off (activated lights are displayed in green).
-------
------- -------
Access the submenu for programming the timer by means of the
-------
timer function. Only the ceiling light (top row) and the outer tent light
(bottom row) can be regulated using the timer. Activate or deacti-
vate the "Off" function as appropriate.
Activated timer
-------
(blue dot)
Programming the timer
-------
Trigger the desired value by means of the arrow keys or the control
knob and press the "On/Off" function or the control knob to select
it. Turn the control knob or use the "+/-" functions to set the time.
0 :00 off
Press the control knob again or use the "On/Off" function to confirm
------- -------
the set time.
Activating/deactivating the timer
The timer will only be activated if the function to the right is changed
from "Off" to "On" (the way to do this is identical to programming
the timer).
Deactivate the timer by setting the function from "On" back to "Off".
Exit this menu by using the "Back" function; otherwise, after one
minute, it will automatically switch back to the main menu on the
control panel.
The activated timer is indicated in the main menu for
the lighting system by a blue dot in the corresponding
light icon.