Hobby ONTOUR Series Operation Manual page 76

7. Installation of electrical devices
Connector pins on 13-pole plug
("Jäger" system)
Operation via base vehicle
During the drive, the battery of the base vehicle takes over the
supply of the 12 V devices if contact 9 of the 13-pole socket sys-
tem on the base vehicle has been equipped.
Use the main switch on the control panel to switch off the 12 V
operation during the drive, on longer stopovers and breaks to
conserve power in the base vehicle's battery.
When running on 12 volts, the refrigerator only functions if the
motor of the base vehicle is turned on. Contacts 10 and 11 of the
13-pole socket system.
Always switch off the electric connection between the
base vehicle and the caravan before hooking the cara-
van up to a low-voltage supply.
If operation is carried out via the base vehicle, a maxi-
mum of 2 electrical devices in the caravan can be swit-
ched at the same time using the control panel (exception:
the self-sufficient package has been installed).
Connector pin assignment of the 13-pole plug („Jäger" outlet)
PIN Colour of
conductor
1 yellow
2 blue
3 white
4 green
5 brown
6 red
7 black
8 orange
9 blue
10 blue/white
11 white/red
12 violet
13 white/blue
Cross Electrical
section devices
1,5 Left blinker
1,5 Fog tail lamp
2,5 Mass (1-8)
1,5 Right blinker
1,5 Right light
1,5 Brake light
1,5 Left light
1,5 Back-up light
2,5 Steady plus
2,5 'Plus' ignition
2,5 Mass (10)
1,5 Camper licence plate
2,5 Mass (9)
72