Hobby ONTOUR Series Operation Manual page 59

1 2 3
6 7 8
13
15
14
55
7. Installation of electrical devices
TFT control panel
4 5
(Premium/Landhaus models or optional extra)
1
2
3
9 10
4
5
6
7
8
9
10
12
13
12
14
15
Functions of the main switch
• After initially connecting the caravan to the 230 V mains, you must
press either the main switch or any other control key in order to
activate all of the 12 V electrical devices and the 230 V electrical
devices that are switched by the system (e.g. therme, floor hea-
ting
• Once the system is in operation, press the main switch briefly to
turn all of the lights off. All of the 12 V steady electrical devices (e.g.
water supply, refrigerator control, heat blower) remain activated.
The devices that were previously switched on are stored in the
system; pressing on the main switch reactivates them. This also
resets the degree to which those lights were dimmed that can be
regulated.
• Pressing the main switch for at least four seconds while the sys-
tem is switched on will turn off not only the presently activated
devices, but also the entire 12 V system (also affects flushing the
toilet and water pump; in self-sufficient campers, this will not cut
off the charging of the battery)
• If there should be a power failure, the system will remember
whether the main switch was on or off. As soon as the power
is back on, the main switch will automatically switch itself back
on. Electrical devices that continuously use current, such as the
heating, will then begin to operate again.
Wall light/lighting in the seating arrangement
Ceiling light
Kitchen lighting
Outer tent light
Therme / boiler
Lighting Ambience 1
Lighting Ambience 2
Lighting Ambience 3
Memory
Floor heating*
Main switch
TFT display: see p. 56
Control knob
Soft keys
*
).
If the selector switch of the Dometic refrigerator has
been set to 12 V, the refrigerator will operate automati-
cally on 12 V when the ignition of the base vehicle has
been switched on, i.e. it is not necessary to press the
main switch.
All other 12 V electrical devices will only operate
on the battery of the base vehicle if they have been
centrally activitated using the main switch
control panel.
on the
12