Hobby ONTOUR Series Operation Manual page 118

12. Maintenance and upkeep
4
Changing the bulb
Writing on the lamp must not be upside
down
6
Registration plate light
7
Releasing the cable
9
Lamp
• Unscrew the light bulb
a new one.
• Carry out this procedure in reverse to put everything back in
place, taking care to ensure that the writing on the lamp
not upside down.
5
Changing the licence plate illumination
• To change the licence plate illumination, first unscrew these
screws
• Release the two cables
(any connection can be chosen).
• When putting in the new light, take care to ensure that the clo-
sed side
ting support
on the lighting support will melt when heat is generated.
8
• Firmly tighten the screws
from the socket and exchange it for
m
If several light bulbs have to be replaced, take care to
ensure that the lamps are not accidentally switched
and that everything goes back in its original place.
.
o
and attach them to the new light
p
of the light points towards the plastic on the ligh-
q
. Otherwise there is a danger that the plastic
r
to fasten the illumination securely.
o
is
n
114