Stuart Turner Monsoon U1.5 bar Twin Installation Instructions Manual page 12

Wiring Diagram (Schematic)
The supply cord and internal wiring within the terminal box are routed
and secured to ensure compliance with the electrical standard
EN 60335-1. It is essential that any disturbance of this internal wiring is
avoided and the factory routing and securing of all internal wiring is
always maintained.
N A M
Fuses
The following fuse size should be used with the appropriate pump.
Supply Cord Replacement
The supply cord and internal wiring within the terminal box are routed
and secured to ensure compliance with the electrical standard EN 60335-1.
It is essential that prior to any disturbance of this internal wiring, all cable
routing and securing details are carefully noted to ensure re-assembly to
the same factory pattern is always maintained.
If the supply cord is to be changed or is damaged, it must be replaced with a special
cord assembly available from Stuart Turner or one of their approved repairers.
On disassembly note the cord retention and routing system. Re-assemble to the same
pattern.
For information on cable connection consult the wiring diagram and cable gland fitting
instructions.
MAIN WINDING
THERMOTRIP
START WINDING
N
L
S1 S2 S3 S3 S2 S1
Model
U4.0 bar Twin
U4.5 bar Twin
All other models
BLUE
CAPACITOR
BLUE
BROWN
GREEN / YELLOW
FLOWSWITCH
REED (S3)
FLOWSWITCH
REED (S2)
PRESSURE
SWITCH (S1)
Fuse Size (AMPS)
13
5
- 12 -
N 230 VAC/1PH/50Hz
L
SUPPLY
E
Fig. 12