Electrical Installation - Stuart Turner Monsoon U1.5 bar Twin Installation Instructions Manual

Typical Low Level Installation
In certain installations it may be necessary to install a 90° bend on the inlet or outlet
connections of the pump before the flexible hose to accommodate a low level installation.
Below are some preferred connection options. All connections seal on the pump body
using a fibre or rubber sealing washer. Tap connector fittings should be used which must
be of an appropriate pressure and temperature rating.
It is essential when using any of the fittings shown below, that a correct water tight seal
is obtained between the pump body and selected fitting and also the flexible hose and
selected fitting. If in doubt contact the fitting manufacturer and confirm compatibility with
the connection to be sealed.
Carefully check connections and pipework for leaks whilst pump running and stationary
before leaving the installation unattended.
G¾ female x 22 mm
elbow tap connector.
22 mm copper pipe.
Fibre washer.
22 mm
elbow.
22 mm
copper
pipe
G¾ female x 22 mm
tap connector.
Fibre washer.
Fig. 10
STEP 5 ELECTRICAL INSTALLATION
WARNINGS:
The electrical installation must be carried out in accordance with the
current national electrical regulations and installed by a competent
person.
In the interests of electrical safety a 30 mA residual current device
(R.C.D.) should be installed in the supply circuit. This may be part of
a consumer unit or a separate unit.
Before starting work on the electrical supply ensure power supply is
isolated.
This appliance must be earthed.
The motor and wiring must not be exposed to water.
Do not allow the supply cord to contact hot surfaces, including the
motor shell, pump body or pipework. The cord should be safely
routed and secured by cable clips.
22 mm compression to
G¾ male.
G¾ female flexible hose
(supplied in kit).
22 mm compression to
G¾ male.
G¾ female x 22 mm
swivel tap connector
with rubber sealing
washer.
G¾ female flexible hose
(supplied in kit).
Sealing washer
(sometimes captured in
fitting)
- 10 -
G¾ female
flexible hose
22 mm to G¾
(supplied in
male. kit).
22 mm stem elbow.
G¾ female x 22 mm
tap connector with
rubber sealing washer.