Mode 1(Optically Linear):
The increase in light intensity appears to be linear as DMX value is increased.
Mode 2(Square Law):
Light intensity control is finer at low levels and coarser at high levels.
Mode 3(Inverse Square Law):
Light intensity control is coarser at low levels and finger at high levels.
Mode 4(S‐cure):
Light intensity control is finger at low levels and high levels and coarser at medium levels.
Sound State
To select Sound State, press the ENTER button to show the SOUND STATE on the display. Use the
DOWN/UP button to select the On (turn on the Sound Mode) or Off (Sound Mode off). Once the
mode has been selected, press the ENTER button to setup, to go back to the functions without any
change press the MENU button again. Press and hold the MENU button for about one second or
wait for one minute to exit the menu mode.
Sound Sense
To select Sound Sense, press the ENTER button to show the SOUND SENSE on the display. Use the
DOWN/UP button to adjust the sensitivity level, the sensitivity level can be adjusted between 0
(the lowest) and 100 (most sensitive). Press and hold the MENU button for about one second or
wait for one minute to exit the menu mode.
Black Out
To select Black Out, press the ENTER button to show the BLACK OUT on the display. Use the
DOWN/UP button to select the Yes (blackout) or No (normal). Once selected, press the ENTER
button to setup, to go back to the functions without any change press the MENU button again.
8A