White Balance
To select White Balance, press the ENTER button to show the WHITE BALANCE on the display. Use
the DOWN/UP button to select the Red or Green, Blue. Once the mode has been selected, press
the ENTER button to setup, use the DOWN/UP button to adjust the value (125~255). Once
selected, press the ENTER button to setup, go back to the functions without any change press the
MENU button again. Press and hold the MENU button for about one second or wait for one
minute to exit the menu mode.
Manual Test
To select Manual Test, press the ENTER button to show the MANUAL TEST on the display. Use the
DOWN/UP button to select the Pan/Tilt/Red/Green/Blue/White/Zoom/Dimmer or Strobe. Once
you find a function or color you wish to test, press the ENTER button and use the DOWN/UP
button to adjust the value (000~255). Once the mode has been selected, press the ENTER button
to setup, go back to the functions without any change press the MENU button again. Press and
hold the MENU button for about one second or wait for one minute to exit the menu mode.
Auto Test
To select Auto Test, press the ENTER button and the unit will run self‐test by built‐in program. To
go back to the functions press the MENU button again. Press and hold the MENU button about
one second or wait for one minute to exit the menu mode.
Temp.
To select Temp., press the ENTER button and the display will show the current temperature of the
unit. When the temperature is under 60℃, the fixture will work normally; when it's between 65
℃ and 75℃, the fixture will reduce the power output; when it reach 75℃ or higher, the LED will
be OFF. To go back to the functions press the MENU button again. Press and hold the MENU
button for about one second or wait for one minute to exit the menu mode.
Fixture Time
To select Fixture Time, press the ENTER button and the display will show the number of working
hours of the unit. To go back to the functions press the MENU button again. Press and hold the
10A