ACME CM-70Z User Manual page 10

Press and hold the MENU button for about one second or wait for one minute to exit the menu
mode.
Back Light
To select Back Light, press the ENTER button to show the BACK LIGHT on the display. Use the
DOWN/UP button to select the On (LED display always on) or Off (LED display off when not use).
Once selected, press the ENTER button to setup, to go back to the functions without any change
press the MENU button again. Press and hold the MENU button for about one second or wait for
one minute to exit the menu mode.
Pan Inverse
To select Pan Inverse, press the ENTER button to show the PAN INVERSE on the display. Use the
DOWN/UP button to select the Yes (pan inversion) or No (normal) mode. Once the mode has
been selected, press the ENTER button to setup, to go back to the functions without any change
press the MENU button again. Press and hold the MENU button for about one second or wait for
one minute to exit the menu mode.
Tilt Inverse
To select Tilt Inverse, press the ENTER button to show the TILT INVERSE on the display. Use the
DOWN/UP button to select the Yes (tilt inversion) or No(normal) mode. Once the mode has been
selected, press the ENTER button to setup, to go back to the functions without any change press
the MENU button again. Press and hold the MENU button for about one second or wait for one
minute to exit the menu mode.
Function Delay
To select the Function Delay, press the ENTER button to show the FUNCTION DELAY on the display.
Use the DOWN/UP button to select the no Delay or 1S Delay, 2S Delay, 3S Delay (wait for 1/2/3
seconds before these functions of 14CH are activated/deactivated). Once selected, press the
ENTER button to setup, to go back to the functions without any change press the MENU button
again. Press and hold the MENU button for about one second or wait for one minute to exit the
menu mode.
9A