Maximum Printing Areas And Margins; Materials Not To Be Printed - Riso MZ770 User Manual

Maximum Printing Areas and Margins

The maximum printing areas are as follows.
Maximum Printing Area
291 mm × 413 mm
Important!:
• No matter which size of originals is printed, the margins indicated on the figure are required for the originals.
Reduce the original if necessary to fit it inside of the margins. Place an original so that its end having a 5 mm margin
at least comes to the left of the Platen Glass.
Tip:
About Printing Areas
• Printing area for the master is determined by the actual paper size detected on the Paper Feed Tray, regardless
of whether the original is being scanned, or sent from a computer.
• As shown in the illustration above, the printing area on the master will be smaller than the paper size (allowing 7mm
total margins for top and bottom, 6 mm for left and right). Peripheral areas in the original document exceeding the
printing area for the master will not be printed.
• The maximum printing area can be applied to the scanned image, regardless of the print paper size.
p.99

Materials Not to Be Printed

Do not use the machine in any manner which violates the law or infringes on established copyrights, even when mak-
ing copies for personal use. Consult your local authorities for further details. In general, use discretion and common
sense.
RISO EUROPE LIMITED & European Subsidiaries
Before Starting to Use
Usable Maximum Print Paper Size
297 mm × 432 mm
Originals 17