Riso MZ770 User Manual page 234

Troubleshooting
Message
Master Mis-Feed
Pull Out Master Making Unit and
Rewind Master Roll, then
Reset Master in Place
Master Not Set in Place
Insert Lead Edge of Master into
Master
Entrance and Close Master Making
Unit
Master Remains on Print Drum 1
Pull Out Print Drum 1 and
Remove Master
Master Remains on Print Drum 2
Pull Out Print Drum 2 and
Remove Master
Safety SW on Standard Feed Tray
is Activated
Reset paper on Standard Feed Tray
System Error in Master Making Unit
Take Out Master and then
Close Master Making Unit Cover
B00-000:Optional Device Error (in alphabetical order)
Message
Data Transfer Error for Linked
Printer
Check Network and Linked Printer
Then Transfer Data Again
Insert Card in Key/Card Counter
!! Job Separator is OFF !!
Turn On Power Switch of it
232 When a Message Displays
Possible Cause
The master is improperly
installed.
The master is improperly
installed or is missing.
An unnecessary master
remains on the Print Drum.
The safety switch for the Paper
Feed Tray has been activated.
The cutter mechanism for the
master malfunctioned.
Possible Cause
Cannot transmit data to Linked
Printer.
No card in the Key Card
Counter (option).
The Job Separator (option) is
turned OFF.
RISO EUROPE LIMITED & European Subsidiaries
Action
Pull out the Master Making Unit, rewind
the master and reinstall.
p.213
Important!:
• If the leading edge of the master is
wrinkled or torn, cut the edge straight
and reinstall.
Pull out the Master Making Unit and
reinstall the master.
p.213
Important!:
• If the leading edge of the master is
wrinkled or torn, cut the edge straight
and reinstall.
1)
Pull out the Print Drum and remove
the master from the drum.
p.220
2)
Return the Print Drum in place.
Check underneath the Paper Feed Tray
and on top of the printing paper for any
obstructions. Remove if any exist.
1)
Either remove the drum and the
master on the drum, or cut evenly and
remove.
2)
Pull out the Master Making Unit and
remove the master.
p.213
3)
Closing the Master Making Unit Cover
will reset the error. Setup the master
again.
Action
Check connections from Linked Printer
and the machine to the hub. If they are
properly connected, check the server and
network communication status and
consult with the network administrator.
Insert Card in the Key Card Counter.
Turn on the Job Separator.