Apache Labs ANAN-200D User Manual page 18

Note: if you get in trouble with settings and wish to RESET your SYSTEM to it's initial state, look at the bottom
of the Setup Menu for the "RESET DATABASE" option. This will over-ride and install a new database with proper
default settings for your ANAN-200D. This can be done at any time. However, it will over-write any special
personalization that you might have selected – such as Panadapter color, Display speed in frames per second
etc.
Go to → GENERAL → Hardware Configuration tab and note the IP Address and MAC address that are read from
the ANAN Transceiver Transceiver.
Note: if the IP ADDRESS is 0.0.0.0 then the software is not communicating with the Transceiver
you must check your LAN connection.
OpenHPSDR/PowerSDR/OpenHPSDR software has not been started
Power button on the rig has not been activated
Also check your LAN connector on the ANAN Transceiver to insure that the Link Light on the LEFT side of the
LAN connector is illuminated.
Copyright Apache Labs © ANAN-200D 18 June 22, 2015