How To Set Up Central Control Address Number - Toshiba RAV-SM564UT-E Service Manual

6. External view of P.C. board assembly
7. Address setup
In addition to set up the central control address, it is necessary to change the indoor unit number.
(Line/Indoor/Group address). For details, refer to TCC-LINK Adapter Installation Manual.

12-3. How to Set up Central Control Address Number

When connecting the indoor unit to the central control remote controller using TCC-LINK adapter, it is neces-
sary to set up the central control address number.
• The central control address number is displayed as the line No. of the central control remote controller.
1. Setup from remote controller at indoor unit side
∗ If you use the network adapter P .C. board, it is effective only when No. 7 of setup switch SW01 on P .C.
board is turned off.
<Procedure> Perform setup while the unit stops.
1
VENT
TEST
Push + buttons for 4 seconds or more.
When group control is executed, first the unit No.
control are selected. In this time, fans of all the selected indoor units are turned on. (Fig. 1)
(Keep displayed status without pushing
In case of individual remote controller which is not group-controlled, Line address and Indoor unit address
are displayed.
2
Using temperature setup
3
Using timer time
The setup data is shown in the table below (Table 1).
4
SET
Push button. (OK if display goes on.)
• To change the item to be set up, return to Procedure
5
TEST
Push button.
The status returns to usual stop status.
(Table 1)
Setup data Central control address No.
0001
0002
0003
:
0064
0099 Unset (Setup at shipment from factory)
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Terminator (SW01)
UNIT LOUVER
TEMP.
buttons, specify item code
TIME buttons, select the setup data.
1
2
3
:
64
www.heronhill.co.uk
85
is displayed and all the indoor units in the group
button.)
!
.
2
.
TEMP.
2
1
FILTER
RESET TEST
5
– 160 –
52
(Fig.1)
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
Fax: 01823 665807
3
1
4