Address Setup (Manual Setting From Remote Controller) - Toshiba RAV-SM564UT-E Service Manual

13-4. Address Setup
In case that addresses of the indoor units will be
determined prior to piping work after cabling work
• Set an indoor unit per a remote controller.
• Turn on power supply.
1
SET CL TEST
Push + + buttons simultaneously
for 4 seconds or more.
2
(← ← ← ← ← Line address)
Using the temperature setup
12
set to the item code.
3
Using timer time
4
SET
Push button. (OK when display goes on.)
5
(← ← ← ← ← Indoor unit address)
Using the temperature setup
6
Using timer time
7
SET
Push button. (OK when display goes on.)
8
(← ← ← ← ← Group address)
Using the temperature setup
9
Using timer time
10
SET
Push button. (OK when display goes on.)
11
TEST
Push button.
Setup completes. (The status returns to the usual stop status.)
2, 5, 8
END
<Operation procedure>
1 2
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
(Manual setting from remote controller)
/ buttons,
/ buttons, set the line address.
/ buttons, set
/ buttons, set 1 to the line address.
/ buttons, set
0000
/ buttons, set to Individual,
TEMP.
TIMER SET
11
FILTER
RESET TEST SET
1
3 4 5 6
www.heronhill.co.uk
(Example of 2-lines cabling)
(Real line: Cabling, Broken line: Refrigerant pipe)
Outdoor
1 2 3
1 2 3
Indoor
A B
Line address → 1
Indoor unit address → 1
Group address → 1
A B
Remote controller
For the above example, perform setting by
connecting singly the wired remote controller
without remote controller inter-unit cable.
Group address
Individual
Master unit : 0001
Sub unit
13
to the item code.
14
to the item code.
0001
to Master unit, and
ON / OFF
FAN MODE
TIME SAVE VENT
CL SWING/FIX UNIT LOUVER
7 8 9 10
– 178 –
Revised 2: Jun., 2008
Outdoor
1 2 3
1 2 3 1 2 3
Indoor Indoor Indoor
A B A B
1 2
2 1
2 2
: 0000
In case of group control
: 0002
0002
to sub unit.
3, 6, 9
4, 7, 10
11
END
Fax: 01823 665807
1 2 3
A B
2
2
2